Los productos PLANTOGEAR S son aceites para engranajes industriales ambientalmente aceptables basados en aceites especiales saturados ésteres sintéticos que garantizan alta resistencia al envejecimiento y excelente protección contra el desgaste – muy buena lubricidad. Los productos tienen una buena solvencia (buenas propiedades detergentes dispersantes debido a los aceites base de éster polar).
Los productos PLANTOGEAR S de muy altas prestaciones contra el rozamiento (antifricción). (FZG > 12). El sistema de aditivos antidesgaste/extrema presión seleccionado garantiza la protección contra el desgaste de los cojinetes debido a los excelentes resultados de la prueba de desgaste de cojinetes de rodillos FE8 (excelente protección contra el desgaste de los cojinetes de rodillos en condiciones severas, alta carga, baja velocidad).
Aplicaciones
Los productos PLANTOGEAR S se pueden utilizar como CLP universal aceites para engranajes industriales. Los productos PLANTOGEAR S pueden ser utilizado en engranajes rectos, cónicos, planetarios y helicoidales, especialmente en áreas ambientalmente sensibles. Los productos también pueden utilizarse en sistemas de accionamiento en áreas de protección de agua donde Las aguas subterráneas y superficiales pueden ser contaminadas por fugas de petróleo. La formulación de la serie PLANTOGEAR S se basa en ésteres de alto rendimiento saturados totalmente sintéticos basados en recursos naturales renovables. Los productos se pueden utilizar en aplicaciones donde el uso de lubricantes sintéticos es de ventaja.
Instrucciones de uso (VER FICHA TÉCNICA)
The PLANTOGEAR S products can be used as a universal industrial gear oil in new gears as well as in used gears. New gears should be flushed and rinsed before applying PLANTOGEAR S. New gears are usually partly filled with mineral oil based corrosion protection and running-in oils after manufacture. If they are not completely flushed, the running-in oil and the corrosion protection oil remains in the gear box and may contaminate the PLANTOGEAR S products. Under unfavourable conditions this can result in increased foam values and this can affect the biodegradability of the PLANTOGEAR S products negatively.
The content of the residual mineral oil should, therefore, be reduced as recommended in the ISO 15380 guideline, table A1 (guidelines for changing fluid from mineral based oils to environmentally acceptable fluids) to a percentage of approximately lower than 2% mineral oil in PLANTOGEAR S.
If an existing gear box is changed-over from a mineral based gear oil to PLANTOGEAR S, the gear box should also be flushed and rinsed so that the residual content
of the previous product can be reduced (preferably <2%).
The internal tank and gear coatings should be compatible with ester based products.
Paints which are not compatible to esters are not recommended to be used. In general two components coating systems can be used with ester based products. The use of stainless steel tanks or stainless steel filter housings is recommended.
When deep filtration filters are used, the good solvency, dissolving properties of the PLANTOGEAR S products can reduce the filter life.
Clean/check or replace the oil filters in the system immediately after changing over to PLANTOGEAR S products. After one week further changing of the oil filter is perhaps relevant. To ensure a safe operation, when using PLANTOGEAR S products in gear and circulating systems, remove any water that may have penetrated the systems before start-up or after longer periods of downtime. We recommend the use of suitable dryer systems and filtration units. Use ester-resistant compatible sealing materials and plastic materials in general. We recommend the use of viton material in dynamic stressed seals.
Observe the change-over recommendations according to ISO 15380, which can be transferred to industrial gear oil applications
Valoraciones
No hay valoraciones aún.